|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 9th, 2008, 10:18 PM
posted to microsoft.public.visio.general
|
|||
|
|||
Circuit diagrams in Visio
Where can I get a template to allow me to draw circuit diagrams using Visio?
I don't need anything too complicated - simple block diagrams would be fine, but I need symbols like opamps, summers, logic gates, etc. 
|
|
#2
September 10th, 2008, 12:41 AM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Circuit diagrams in Visio
On Tue, 9 Sep 2008 14:18:01 -0700, DavidS
wrote: Where can I get a template to allow me to draw circuit diagrams using Visio? I don't need anything too complicated - simple block diagrams would be fine, but I need symbols like opamps, summers, logic gates, etc. Would you care to have a look at my http://www.electronics.sandrila.co.uk/ Should be everything you need. -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/
|
|
#3
September 11th, 2008, 12:26 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Circuit diagrams in Visio
DavidS wrote:
Where can I get a template to allow me to draw circuit diagrams using Visio? I don't need anything too complicated - simple block diagrams would be fine, but I need symbols like opamps, summers, logic gates, etc. Do you mean international (IEC) symbols, or American symbols? (I wonder if the USA will ever join the rest of the world? Units of measure, too. Imagine a modern technological nation still grappling with those archaic, obfuscatory Imperial inch, mile and pound thingies, 230 years after they gave the Empire the flick???) Paddy
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
