If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Error when Pasteing a word table into visio 2007
I am trying to copy the letterhead of a word document and paste it into a
visio drawing. The letterhead is in the header of the word document and is in a table. I tried to copy the table and then paste it at the top of my visio drawing but get an error message. The error message reads: "An error (1) occured during the action Paste Unexpected end of file" I am using Visio 2007 and tried to copy from both word 2003 and word 2007 documents. Does anyone know what this means and if there is another way that I can copy from word into visio? -- Janet M. |
#2
|
|||
|
|||
Error when Pasteing a word table into visio 2007
On Tue, 27 Nov 2007 11:58:02 -0800, Janet M
wrote: I am trying to copy the letterhead of a word document and paste it into a visio drawing. The letterhead is in the header of the word document and is in a table. I tried to copy the table and then paste it at the top of my visio drawing but get an error message. The error message reads: "An error (1) occured during the action Paste Unexpected end of file" I am using Visio 2007 and tried to copy from both word 2003 and word 2007 documents. Does anyone know what this means and if there is another way that I can copy from word into visio? Have you tried Paste Special? -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/ |
#3
|
|||
|
|||
Error when Pasteing a word table into visio 2007
Did u try reformatting the header as NORMAL ? then cc/paste?
"Janet M" wrote: I am trying to copy the letterhead of a word document and paste it into a visio drawing. The letterhead is in the header of the word document and is in a table. I tried to copy the table and then paste it at the top of my visio drawing but get an error message. The error message reads: "An error (1) occured during the action Paste Unexpected end of file" I am using Visio 2007 and tried to copy from both word 2003 and word 2007 documents. Does anyone know what this means and if there is another way that I can copy from word into visio? -- Janet M. |
Thread Tools | |
Display Modes | |
|
|