multiple selection in report

I have a report that prints from a multiple selection. For example, field
could equal any combination of Airframe, LH Engine, RH Engine, etc, and I
want the report to seperate them, Airframe report, LH Engine report, etc. At
the moment I get a report that prints the data for every combination.

Rachel Ruta wrote:
I have a report that prints from a multiple selection. For example, field
could equal any combination of Airframe, LH Engine, RH Engine, etc, and I
want the report to seperate them, Airframe report, LH Engine report, etc. At
the moment I get a report that prints the data for every combination.

You mean you're trying to filter your report based on selections in a multi-
select listbox?
http://www.mvps.org/access/reports/rpt0005.htm

You would just open the filtered report, print it out, close the report, then
open again with a new filter (the next one in the list).

--
Message posted via AccessMonster.com
http://www.accessmonster.com/Uwe/For...ports/201004/1

Thanks Pieter, this worked, however I wanted the report to print all of the
selection in one task, e.g. Report for Airframe, LH Engine, RH Engine, etc.

"PieterLinden via AccessMonster.com" wrote:

Rachel Ruta wrote:
I have a report that prints from a multiple selection. For example, field
could equal any combination of Airframe, LH Engine, RH Engine, etc, and I
want the report to seperate them, Airframe report, LH Engine report, etc. At
the moment I get a report that prints the data for every combination.

You mean you're trying to filter your report based on selections in a multi-
select listbox?
http://www.mvps.org/access/reports/rpt0005.htm

You would just open the filtered report, print it out, close the report, then
open again with a new filter (the next one in the list).

--
Message posted via AccessMonster.com
http://www.accessmonster.com/Uwe/For...ports/201004/1

.