If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Master custom properties don't transfer to drawing instance
In Vision 2000 SR1, I’ve made changes to the custom properties of master
shape on a stand alone stencil. When I drop an instance of that master on a drawing page, there aren’t any custom properties in that instance. Nothing shows up in the custom properties dialog box of that drawing shape but the master still has all the custom properties. What am I doing wrong? |
#2
|
|||
|
|||
Once you drag the shape to the drawing and add the custom properties, select
the master on the Stencil (the stencil has to be in edit mode) and delete it. Drag the copy on the drawing to the stencil and use this as the master. "JStouffer" wrote: In Vision 2000 SR1, I’ve made changes to the custom properties of master shape on a stand alone stencil. When I drop an instance of that master on a drawing page, there aren’t any custom properties in that instance. Nothing shows up in the custom properties dialog box of that drawing shape but the master still has all the custom properties. What am I doing wrong? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Custom Master Category List | Steve Morey | Contacts | 1 | August 18th, 2004 10:12 PM |
Custom Properties Ordering them A-Z | [email protected] | Visio | 1 | June 8th, 2004 05:47 PM |
Using Custom Properties | PR | Formatting Long Documents | 2 | June 7th, 2004 05:17 PM |
Custom Properties | Chris Warlick | Visio | 1 | June 1st, 2004 10:53 PM |
This is a tough one!!!! | artman | Visio | 1 | May 27th, 2004 10:16 PM |