|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 17th, 2009, 07:47 PM
posted to microsoft.public.access.reports
|
|||
|
|||
How can I add 3 pages of formatted text to the beginning of a repo
How can I add 3 pages of formatted text to the beginning of a report? It
seems to only allow two in the report header. Thank you! 
|
|
#2
August 17th, 2009, 08:09 PM
posted to microsoft.public.access.reports
|
|||
|
|||
|
How can I add 3 pages of formatted text to the beginning of arepo
The maximum size of any section is 22 inches.
You can add another section that will print once by adding a group header to your report and adding one page of the formatted text to the group header. Set the value for the group header to =1 and don't repeat the header on subsequent pages. An alternative that should work is to shrink your controls so that they are not displaying all the information in design view and then use the can grow property of the controls and the section to allow them to grow. (I've experimented with this to see if the section can grow beyond 22 inches when printing or displaying in preview mode and it will grow beyond the 22 inch limit.) John Spencer Access MVP 2002-2005, 2007-2009 The Hilltop Institute University of Maryland Baltimore County Paul wrote: How can I add 3 pages of formatted text to the beginning of a report? It seems to only allow two in the report header. Thank you!
|
|
#3
August 18th, 2009, 12:36 AM
posted to microsoft.public.access.reports
|
|||
|
|||
|
How can I add 3 pages of formatted text to the beginning of a
Thank you! I will try it out.
"John Spencer" wrote: The maximum size of any section is 22 inches. You can add another section that will print once by adding a group header to your report and adding one page of the formatted text to the group header. Set the value for the group header to =1 and don't repeat the header on subsequent pages. An alternative that should work is to shrink your controls so that they are not displaying all the information in design view and then use the can grow property of the controls and the section to allow them to grow. (I've experimented with this to see if the section can grow beyond 22 inches when printing or displaying in preview mode and it will grow beyond the 22 inch limit.) John Spencer Access MVP 2002-2005, 2007-2009 The Hilltop Institute University of Maryland Baltimore County Paul wrote: How can I add 3 pages of formatted text to the beginning of a report? It seems to only allow two in the report header. Thank you!
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
