If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
how to I restore a shape to a master?
I have edited master shapes and now what to go through an existing
document and restore shapes created in it using the new master styles. How do I do this? |
#2
|
|||
|
|||
how to I restore a shape to a master?
With a little 29 $ utility from Visimation. I haven't tried it yet, but I
only had a quick look at my trial version and it seems it will do the job. "sara" wrote: I have edited master shapes and now what to go through an existing document and restore shapes created in it using the new master styles. How do I do this? |
#3
|
|||
|
|||
how to I restore a shape to a master?
On Mon, 11 Feb 2008 18:45:18 -0800 (PST), sara
wrote: I have edited master shapes and now what to go through an existing document and restore shapes created in it using the new master styles. How do I do this? If I read your question correctly you want to substitute one or more shape for another. We have a utility to do this http://www.visio-utilities.sandrila.co.uk/ There is a shape substitute that will do this for you. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/ |
Thread Tools | |
Display Modes | |
|
|