|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 14th, 2008, 06:19 PM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
Word default view
How do I get a normal view as default, the way it used to be. It is very
disturbing to see all the arrows and symbols while I work. 
|
|
#2
November 14th, 2008, 07:35 PM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
|
Word default view
Press Ctrl+*
-- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA "Tj" wrote in message ... How do I get a normal view as default, the way it used to be. It is very disturbing to see all the arrows and symbols while I work.
|
|
#3
September 23rd, 2009, 09:49 PM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
|
Normal view
Wish I knew - I've just had the earlier (poor) view replaced with a new, worse one.
Posted as a reply to: Word default view 14-Nov-08 How do I get a normal view as default, the way it used to be. It is very disturbing to see all the arrows and symbols while I work. EggHeadCafe - Software Developer Portal of Choice WPF And The Model View View Model Pattern http://www.eggheadcafe.com/tutorials...l-view-vi.aspx
|
|
#4
September 23rd, 2009, 11:27 PM
posted to microsoft.public.word.pagelayout
|
|||
|
|||
|
Normal view
You can see this post that's nearly a year old and yet you cannot see the
answers that were posted at the time? Perhaps you should move to a better portal. In any case, if what you're complaining of is actually the same as the original poster, see http://word.mvps.org/FAQs/Formatting/NonPrintChars.htm. But I suspect you're talking about the Word 2007 UI rather than nonprinting characters. -- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA http://word.mvps.org Phil Firefall wrote in message ... Wish I knew - I've just had the earlier (poor) view replaced with a new, worse one. Posted as a reply to: Word default view 14-Nov-08 How do I get a normal view as default, the way it used to be. It is very disturbing to see all the arrows and symbols while I work. EggHeadCafe - Software Developer Portal of Choice WPF And The Model View View Model Pattern http://www.eggheadcafe.com/tutorials...l-view-vi.aspx
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
