If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
grid off on one page
Is it possible to turn the grid off of only one page?
thanks |
#2
|
|||
|
|||
grid off on one page
On Thu, 14 Feb 2008 10:37:11 -0600, "greg" wrote:
Is it possible to turn the grid off of only one page? Not really as it is a document wide setting.... however, there is workaround open the page shapesheet menu window - Show shapesheet and set XGridSpacing and YGridSpacing to a large value. -- Regards, Paul Herber, Sandrila Ltd. SSADM for Visio http://www.saadm.sandrila.co.uk/ |
#3
|
|||
|
|||
grid off on one page
On Thu, 14 Feb 2008 16:47:53 +0000, Paul Herber
wrote: On Thu, 14 Feb 2008 10:37:11 -0600, "greg" wrote: Is it possible to turn the grid off of only one page? Not really as it is a document wide setting.... however, there is workaround open the page shapesheet menu window - Show shapesheet and set XGridSpacing and YGridSpacing to a large value. or use the menu Tools - Ruler and Grid -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.electronics.sandrila.co.uk/ |
#4
|
|||
|
|||
grid off on one page
OK,
Set the XGridSpacing and YGridSpacing to 10. seems pretty good. thanks "Paul Herber" wrote in message ell.net... On Thu, 14 Feb 2008 10:37:11 -0600, "greg" wrote: Is it possible to turn the grid off of only one page? Not really as it is a document wide setting.... however, there is workaround open the page shapesheet menu window - Show shapesheet and set XGridSpacing and YGridSpacing to a large value. -- Regards, Paul Herber, Sandrila Ltd. SSADM for Visio http://www.saadm.sandrila.co.uk/ |
#5
|
|||
|
|||
grid off on one page
Ah, you are using inches! I was working in mm, 1000 being more
appropriate in my case. On Thu, 14 Feb 2008 12:42:20 -0600, "greg" wrote: OK, Set the XGridSpacing and YGridSpacing to 10. seems pretty good. thanks "Paul Herber" wrote in message well.net... On Thu, 14 Feb 2008 10:37:11 -0600, "greg" wrote: Is it possible to turn the grid off of only one page? Not really as it is a document wide setting.... however, there is workaround open the page shapesheet menu window - Show shapesheet and set XGridSpacing and YGridSpacing to a large value. -- Regards, Paul Herber, Sandrila Ltd. http://www.sdl.sandrila.co.uk/ SDL/MSC/TTCN/URN/UML2 for Visio |
Thread Tools | |
Display Modes | |
|
|