|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 12th, 2008, 03:14 PM
posted to microsoft.public.visio.general
|
|||
|
|||
Combining information from several different drawings (Gantt chart
I was wondering if there was a way to break out information from 4 different
Gantt charts (separated by quarters) to display information from each quarter on a separate chart, i.e. all Q1 information on one chart, etc? Thank you for any information you may be able to provide. 
|
|
#2
February 13th, 2008, 11:04 AM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Combining information from several different drawings (Gantt chart
On Tue, 12 Feb 2008 07:14:01 -0800, PhillipP
wrote: I was wondering if there was a way to break out information from 4 different Gantt charts (separated by quarters) to display information from each quarter on a separate chart, i.e. all Q1 information on one chart, etc? Thank you for any information you may be able to provide. Can you not just copy and paste the appropriate parts into a new page or diagram? -- Regards, Paul Herber, Sandrila Ltd http://www.electronic-chip-packages.sandrila.co.uk/
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
