A Microsoft Office (Excel, Word) forum. OfficeFrustration

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » OfficeFrustration forum » Microsoft Excel » New Users
Site Map Home Register Authors List Search Today's Posts Mark Forums Read  

Screen Size ?



 
 
Thread Tools Display Modes
  #1  
Old March 17th, 2009, 01:06 PM posted to microsoft.public.excel.newusers
Robert11[_3_]
external usenet poster
 
Posts: 76
Default Screen Size ?

Hello,

Using Excel 2007, and XP.

The screen opens up too large for my CRT monitor.

Probably not all that much, but enough so that I can't grab any of the edges
to make smaller, or the minimize box in the upper right corner.

So, I can't drag the full screen around any.

This is the only program that I have this trouble with.

Is there anything in Excel that I can tell to re-size the full screen
smaller when it opens ?

Thanks,
Bob



  #2  
Old March 18th, 2009, 10:54 AM posted to microsoft.public.excel.newusers
OssieMac
external usenet poster
 
Posts: 862
Default Screen Size ?

Hi Bob,

When you say "This is the only program that I have this trouble with" do you
mean that all of your other applications fit the screen properly when
maximized or do you mean that the other applications simply do not open with
maximized screen and therefore do not present a problem?

If other applications do not fit the screen when maximized then it indicates
that you need to adjust the screen controls (Usually buttons on the front of
the sceen where one main button brings up a menu and you use arrows to scroll
to the required menu item and then select the menu item with the main button
again and then used the arrows to alter the values for the selected item.
There is a lot of different ways that the buttons work so consult the manual
for the CRT if you can't work it out.)

Now if the above is not your problem and other applications when mazimized
fill the screen to the correct size, can you see the top bar of the window
with the Workbook name and Microsoft Excel? If you can then you can right
click on it and select Restore to reduce the screen size.

If other applications are OK and only Microsoft Excel presents a problem
then I don't know what the answer is to correct the problem properly; only
the work around in the previous paragraph.

--
Regards,

OssieMac


"Robert11" wrote:

Hello,

Using Excel 2007, and XP.

The screen opens up too large for my CRT monitor.

Probably not all that much, but enough so that I can't grab any of the edges
to make smaller, or the minimize box in the upper right corner.

So, I can't drag the full screen around any.

This is the only program that I have this trouble with.

Is there anything in Excel that I can tell to re-size the full screen
smaller when it opens ?

Thanks,
Bob




  #3  
Old March 18th, 2009, 11:01 AM posted to microsoft.public.excel.newusers
OssieMac
external usenet poster
 
Posts: 862
Default Screen Size ?

Hi again Bob,

I should also have said that right clicking on the Microsoft Excel name in
the task bar at the bottom of the screen gives you the same options as the
top bar of the screen to restore.

--
Regards,

OssieMac


  #4  
Old March 18th, 2009, 10:43 PM posted to microsoft.public.excel.newusers
Robert11[_3_]
external usenet poster
 
Posts: 76
Default From OP: Screen Size ?

Hi,

Thanks for help and suggestions.
Appreciate it very much, as well as the past help.

Was finally able to grab a (very) small section of an edge of the Excel
screen,
and re-size it that way.

Sure is funny the way it opened bigger than any other program's screen I
have.

But, all is fine now.

Thanks again,
Bob

-------------------------------
"Robert11" wrote in message
...
Hello,

Using Excel 2007, and XP.

The screen opens up too large for my CRT monitor.

Probably not all that much, but enough so that I can't grab any of the
edges to make smaller, or the minimize box in the upper right corner.

So, I can't drag the full screen around any.

This is the only program that I have this trouble with.

Is there anything in Excel that I can tell to re-size the full screen
smaller when it opens ?

Thanks,
Bob





 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 05:27 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 OfficeFrustration.
The comments are property of their posters.