If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
there's not enough memory error
Hi,
Sometimed while working on my database I get a terrible error message that says "there's not enough memory to perform this action.Close unneeded programs and try the operation again",then whenever i try to open this form in design view or in form view i get the same message,is there a way to deal with the form? |
#2
|
|||
|
|||
there's not enough memory error
Hi Pietro
Bad news! Not that I've found! BUT go back to your last backup, copy it!! then repair and compact the original and start from there again! with a problem/complicated form keep copying it within the data base as you develop it. If the problem persists just rebuilld it frm scratch - it doesn't usually take as long as you anticipate! Good luck! "Pietro" wrote in message ... Hi, Sometimed while working on my database I get a terrible error message that says "there's not enough memory to perform this action.Close unneeded programs and try the operation again",then whenever i try to open this form in design view or in form view i get the same message,is there a way to deal with the form? |
#3
|
|||
|
|||
there's not enough memory error
"Pietro" сообщил(а) в новостях ... Hi, Sometimed while working on my database I get a terrible error message that says "there's not enough memory to perform this action.Close unneeded programs and try the operation again",then whenever i try to open this form in design view or in form view i get the same message,is there a way to deal with the form? |
Thread Tools | |
Display Modes | |
|
|