If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
default properties shapes and connector lines
Hi,
How can I permanently change the default properties for connector lines and for shapes? Specifically, I would like for all connector lines to be rounded by 0.125 in. and for all shapes that are dragged onto the drawing space to have a specific fill color. Right now, I need to change the properties manually in every instance. Thanks! |
#2
|
|||
|
|||
The best way is to amend the master that you are using.
Most masters can be altered before the are used, however the Dynamic Connector is ceated when you use the connector tool. So, the trick is to use it once in your template, then delete the line you drew, open the document stencil, and edit the Dynamic Connector that is there. Then save your template, and whenever you base a drawing on that template, it wil use your variant of the Dynamic Connector. "Nocturn16" wrote in message ... Hi, How can I permanently change the default properties for connector lines and for shapes? Specifically, I would like for all connector lines to be rounded by 0.125 in. and for all shapes that are dragged onto the drawing space to have a specific fill color. Right now, I need to change the properties manually in every instance. Thanks! |
Thread Tools | |
Display Modes | |
|
|