If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
How can I get list box data to appear on a report?
On Mon, 12 Mar 2007 12:18:35 -0700, Duane Hookom
wrote: I might be lazy but nearly every table I create has a primary key of autonumber type. I will always create other indexes and some of these might be unique. My foriegn key fields then are almost always long integers. This is a higly debateable subject but I have found that my solution has worked flawlessly for me in every application I create. Writing any program in any language is as much art as science. You can give the same problem to 5 good programmers. They will each produce programs that run flawlessly and produce identical rersults. And no two programs will be alike. Chuck -- |
|
Thread Tools | |
Display Modes | |
|
|