|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 19th, 2004, 04:31 PM
|
|||
|
|||
Setting default Styles
I'm using Visio 2002 SP2. When I open a new drawing my style is showing as
Basic/Ariel/8pt. I would like to change that style to Basic/Times New Roman/12pt. I have looked everywhere in the product and cannot find it. One place I was able to change the attributes, hit OK, and when I came back into Visio it still had the same old defaults. Is this changable? -- Ken Burton 
|
|
#2
October 19th, 2004, 05:36 PM
|
|||
|
|||
|
You might check over in the BLOG
http://blogs.msdn.com/mailant al "Ken Burton" wrote in message ... I'm using Visio 2002 SP2. When I open a new drawing my style is showing as Basic/Ariel/8pt. I would like to change that style to Basic/Times New Roman/12pt. I have looked everywhere in the product and cannot find it. One place I was able to change the attributes, hit OK, and when I came back into Visio it still had the same old defaults. Is this changable? -- Ken Burton
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Change MS Excel Default Macro Security Setting | John | Setting up and Configuration | 1 | October 8th, 2004 04:14 PM |
| How do I change the default setting concerning line spacing? | disseminatethis | General Discussion | 2 | October 1st, 2004 07:47 PM |
| default country setting while creating a new contact... | Scott | Contacts | 1 | April 28th, 2004 11:34 PM |
Linear Mode
