If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Visio 2003
Question:
In Visio 2003, I have just "glued" a curved road to a "4-way crossroad". When the glue was completed, the midpoint selection handles turned "red". Can someone tell me why this happens or point me to the answer. Thanks Neal |
#2
|
|||
|
|||
In this case, 2-D glue is being used because both shapes are 2-D shapes.
Normally 1-D shapes are glued to 2-D shapes. The curved road looks like a 1-D shape but is really a 2-D. -- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Neal Kingcade" wrote in message om... Question: In Visio 2003, I have just "glued" a curved road to a "4-way crossroad". When the glue was completed, the midpoint selection handles turned "red". Can someone tell me why this happens or point me to the answer. Thanks Neal |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Visio 2003 saved as should "stick"; have to choose each time | Bri Loftis | Visio | 1 | September 23rd, 2004 08:46 PM |
Visio Viewer 2003 on Windows XP | mal2 | Visio | 1 | June 10th, 2004 09:12 PM |
Upgrading to 2003 | Steve | Visio | 3 | May 28th, 2004 02:53 PM |
Compare Visio Technical 5 and Visio Professional | Evelyn | Visio | 2 | May 27th, 2004 07:25 PM |