If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Switchboard Design view
Probably a stupid question but I created a switchboard with 4 options.
However when I go into design view it only shows option one. How do I get the other options to show in design view? |
#2
|
|||
|
|||
Switchboard Design view
A switchboard form is very different form a normal form; it works by storing
its details in a table. The layout of the controls on the form is then determined by code in the form's module at runtime. If you want a switchboard form whose layout you can modify in design view you will need to design your own, creating an unbound form, adding controls to it and writing code in the controls' event procedures. Ken Sheridan Stafford, England "Taz" wrote: Probably a stupid question but I created a switchboard with 4 options. However when I go into design view it only shows option one. How do I get the other options to show in design view? |
Thread Tools | |
Display Modes | |
|
|