If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Orientation for DoCmd.OutPutTo method
I'm running an Access 97 (yes it needs to be upgraded) app that incorporates
faxing capabilities. I use the DoCmd.OutPutTo command to copy a report to a ..snp file, which is then faxed. The report is in landscape mode. When I view the sent fax from the FaxConsole, it is in landscape, but it the image/page is turned in portrait mode. When I create this snp file, can I set it up so that it will display in landscape mode when I view the image from the FaxConsole? Thanks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Line Method Explanation? | Joanthan | Setting Up & Running Reports | 5 | April 9th, 2006 05:12 PM |
Most Efficient Calculation Method? | MikeC | Setting Up & Running Reports | 1 | June 21st, 2005 03:27 PM |
Report orientation does not "stick" | Henry Chen | Setting Up & Running Reports | 6 | May 25th, 2005 02:36 AM |
Causing an event or method call in an animation sequence | joel | Powerpoint | 6 | March 31st, 2005 04:06 AM |
code method to switch views | scott | Using Forms | 4 | July 7th, 2004 11:19 PM |