If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Default Printer
Hi All,
I have an Access XP application with 100+ reports in it. I am encountering problems when I distribute the app to other users that don't necessarily have the same printers as I do on my system. I save all my reports that I develope with 'default printer' selected under the Page Setup dialog box and figure that if I move the app to another system it will use their 'Default Printer'. It seems that this is not happening and when they try and run the report it gives them an error to the effect that the printer the report was formatted for is not available and therefore can't preview the report. My only work around right now is to save all my reports to a specific printer "Adobe PDF" which we all have. I would prefer not to have to do this but can't seem to find another solution. Thanks in advance for any solutions or suggestions! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Word default printer | KathyF | General Discussion | 0 | June 14th, 2004 04:31 PM |
Printer disappears when default is set to a network printer | Tony | General Discussion | 1 | June 10th, 2004 12:20 PM |
Default Printer Problems | Ella | Setting Up & Running Reports | 1 | June 7th, 2004 12:01 AM |
Returning to Default Printer | Ken | General Discussion | 4 | June 5th, 2004 08:17 AM |