If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Setup did not complete successfully
I have Office Small Business 2007 installed. I inserted disk 1 to
change the components installed, setup tried to run and then I received the message "Setup did not complete successfully. An error occurred during the installation and setup was unable to complete." I sent the error report to MS. This error results every time I insert disk 1. Disk 2 setup works fine. I concluded I may have a bad disk and contacted MS for replacement disks. The replacement disk 1 still gives me the same error message. Replacement disk 2 works as it should. I tried all of the following, but still get the error: - ran setup from autorun - bypassed autorun and ran setup directly by executing setup.exe - ran setup from My Computer - ran setup in Windows Safe Mode I thought about uninstalling, but if I do and the problem persists, my ability to run my business stops dead. Any ideas on what I should do? |
Thread Tools | |
Display Modes | |
|
|