If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Enlarging objects?
Hello,
I have a Visio project I need sent to a plotter. The object is only 1/10th the size of the plotter paper, I want to increase it be page sized. however, the only handles free are for width, not height. The handles for height are locked (greyed out) So I make the object the width of the page only? So the object is locked - any idea how to unlock it? Any ideas how to increase the height of the object? Alternatives? Thanks, Tmuld |
#2
|
|||
|
|||
Enlarging objects?
On Thu, 21 Jun 2007 07:32:16 -0700, Tmuldoon
wrote: Hello, I have a Visio project I need sent to a plotter. The object is only 1/10th the size of the plotter paper, I want to increase it be page sized. however, the only handles free are for width, not height. The handles for height are locked (greyed out) So I make the object the width of the page only? So the object is locked - any idea how to unlock it? Any ideas how to increase the height of the object? Alternatives? menu File - page Setup Page Size tab and select "Size to fit drawing contents" -- Regards, Paul Herber, Sandrila Ltd http://www.electronic_chip_packages.sandrila.co.uk/ |
Thread Tools | |
Display Modes | |
|
|