If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Wall Dimensions Change
I'm not very experienced with Visio so my probem probably has a simple
answer. I am using the wall shapes to lay out a simple rectangle. One wall is 10 feet long. When I join this wall to another wall, the size of the wall decreases by the width of the wall I'm joining to. I have disabled the snap and grid, thinking that this would prevent this from happening. I want the wall to butt up against the 10 foot wall at a corner. But it seems that Visio wants this to be represented by a 45 degree miter joint and changes the length accordingly. Can someone tell me how to get around this? Thanks In Advance. |
#2
|
|||
|
|||
Wall Dimensions Change
I am also "fit-to-be-tied" with the same problem that Larry has. Even through
I turn off Glue and then Snap, Vision wants to glue walls together, change their lengths, and prevent ungluing. It's maddening! I am trying to enter the basic walls of a building footprint from a detailed architect's drawing. I drag a wall into the workarea, right-click it, and then select Properties where I type in the length and width (e.g., 27 ft. 4 in. and 24 in. for width) of a wall section. This seems straightforward. But then when I try to join with another wall all sorts of untoward things happen! Can anyone help us with a basic approach. George ' -- George F "Larry" wrote: I'm not very experienced with Visio so my probem probably has a simple answer. I am using the wall shapes to lay out a simple rectangle. One wall is 10 feet long. When I join this wall to another wall, the size of the wall decreases by the width of the wall I'm joining to. I have disabled the snap and grid, thinking that this would prevent this from happening. I want the wall to butt up against the 10 foot wall at a corner. But it seems that Visio wants this to be represented by a 45 degree miter joint and changes the length accordingly. Can someone tell me how to get around this? Thanks In Advance. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Change value in cell | Chey | General Discussion | 1 | March 8th, 2006 05:40 PM |
How to hide wall dimensions that dispaly automatically | ericnath75 | Visio | 2 | July 8th, 2005 05:49 PM |
How can I display the inside wall to inside all dimensions? | stevem | Visio | 0 | November 11th, 2004 03:13 AM |
After change of daylight saving time all meetings one hour back! | dellborg | Calendar | 0 | November 8th, 2004 01:49 PM |
how do I change button color | Vivacious-Lady | Database Design | 1 | October 18th, 2004 05:21 PM |