|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 13th, 2006, 03:36 PM
posted to microsoft.public.word.tables
|
|||
|
|||
Bold format for new text
I have a table with 3 columns. What code can I use to force any new text
typed into column 2 to be formatted in Bold (leaving the existing text as is). TIA, David 
|
|
#2
October 13th, 2006, 03:45 PM
posted to microsoft.public.word.tables
|
|||
|
|||
|
Bold format for new text
I should also point out that the new text is always at the end of the
existing text. "Compass Rose" wrote: I have a table with 3 columns. What code can I use to force any new text typed into column 2 to be formatted in Bold (leaving the existing text as is). TIA, David
|
|
#3
October 13th, 2006, 03:47 PM
posted to microsoft.public.word.tables
|
|||
|
|||
|
Bold format for new text
I should also point out that the new text is always at the end of any
existing text. "Compass Rose" wrote: I have a table with 3 columns. What code can I use to force any new text typed into column 2 to be formatted in Bold (leaving the existing text as is). TIA, David
|
|
#4
October 13th, 2006, 03:52 PM
posted to microsoft.public.word.tables
|
|||
|
|||
|
Bold format for new text
I should also point out that the new text is always at the end of any
existing text. "Compass Rose" wrote: I have a table with 3 columns. What code can I use to force any new text typed into column 2 to be formatted in Bold (leaving the existing text as is). TIA, David
|
|
#5
October 13th, 2006, 04:52 PM
posted to microsoft.public.word.tables
|
|||
|
|||
|
Bold format for new text
Sorry for the multiple posts, but after posts 1 and 2, I got an error message
saying that the posts didn't go through and try again later. Can you believe anything you read? "Compass Rose" wrote: I have a table with 3 columns. What code can I use to force any new text typed into column 2 to be formatted in Bold (leaving the existing text as is). TIA, David
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
