|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 28th, 2005, 01:49 PM
|
|||
|
|||
Drill down feature
Hi all
I've searched the web and haven't found any info abount drill down feature for access subreports. Is it available? If yes how do I set it up? Thanks! 
|
|
#2
May 28th, 2005, 02:56 PM
|
|||
|
|||
|
Reports are static. There are no dynamic features like drill down.
-- Doug Steele, Microsoft Access MVP http://I.Am/DougSteele (no e-mails, please!) "Zirc" wrote in message ... Hi all I've searched the web and haven't found any info abount drill down feature for access subreports. Is it available? If yes how do I set it up? Thanks!
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How can I get the "hang up when finished" feature back when the s. | smwc | General Discussion | 1 | April 8th, 2005 04:43 PM |
| Office 2003 installation problem, log file attached.... | Ryan | Setup, Installing & Configuration | 0 | January 20th, 2005 06:57 PM |
| Turning off Outline Feature | Sharon | Tables | 1 | December 12th, 2004 07:16 AM |
| Does Word have a feature comparable to Quick Mark in WordPerfect? | Debby | General Discussion | 2 | September 19th, 2004 09:20 PM |
| keeping the drill down feature after saving as html | kelticfrog | Visio | 0 | August 9th, 2004 08:25 PM |
Linear Mode
