If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cross Refernce: "Insert reference to" attribute
When selecting different types of cross references, the "Insert Reference
Type" always goes to "Entire Caption" for Tables and figures. I alway use "Only Lable and Number". Is there any way of setting this as an option to come up by default. |
#2
|
|||
|
|||
Cross Refernce: "Insert reference to" attribute
I asked the same question a few months ago and got the following macros,
courtesy of Macropod (Word MVP). Sub InsertFigureXRef() Dim I As Integer With Dialogs(wdDialogInsertCrossReference) For I = 1 To 8 SendKeys "{DOWN}" Next SendKeys "{UP}{TAB}:" For I = 1 To 5 SendKeys "{UP}" Next SendKeys "{DOWN}{TAB}{TAB} %v": .Show End With End Sub Sub InsertTableXRef() Dim I As Integer With Dialogs(wdDialogInsertCrossReference) For I = 1 To 8 SendKeys "{DOWN}" Next SendKeys "{TAB}:" For I = 1 To 5 SendKeys "{UP}" Next SendKeys "{DOWN}{TAB}{TAB} %v": .Show End With End Sub These two macros I have attached to two icons I have designed but you can assign a keyboard short cut or just add them to a menu somewhere. Hope this helps DeanH "Tallowood" wrote: When selecting different types of cross references, the "Insert Reference Type" always goes to "Entire Caption" for Tables and figures. I alway use "Only Lable and Number". Is there any way of setting this as an option to come up by default. |
Thread Tools | |
Display Modes | |
|
|