If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do I open outlook when having problems with exchange server
I am trying to set up Outlook 2003 for the first time, The exchange server
got put in instead of a pop3 setting. I cannot get outlook to even open up enough to fix the problem, Can anyone help me? |
#2
|
|||
|
|||
How do I open outlook when having problems with exchange server
You can access the accounts from the Control Panel's Mail applet.
"Associate Executive" Associate wrote in message ... I am trying to set up Outlook 2003 for the first time, The exchange server got put in instead of a pop3 setting. I cannot get outlook to even open up enough to fix the problem, Can anyone help me? |
#3
|
|||
|
|||
How do I open outlook when having problems with exchange server
Hi,
Try creating a new profile and configure the email accounts through the Control Panel. Refer the following link for additional info:- http://support.microsoft.com/default...b;en-us;829918 Thanks, Mittu "Associate Executive" wrote: I am trying to set up Outlook 2003 for the first time, The exchange server got put in instead of a pop3 setting. I cannot get outlook to even open up enough to fix the problem, Can anyone help me? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Outlook 2003 sync with new exchange 2003 server | UTN | General Discussion | 5 | November 22nd, 2005 04:53 PM |
Outlook 2003 in Exchange mode - mailmerge fails | Roger Davis | Installation & Setup | 6 | October 23rd, 2005 04:05 AM |
Copying email accounts to a new profile | Ian | Installation & Setup | 4 | June 22nd, 2004 04:05 PM |
Outlook shortcuts are not working after server migration | Lijo George | Installation & Setup | 0 | June 16th, 2004 05:23 PM |
Unsafe Attachments | Ron | Installation & Setup | 2 | June 9th, 2004 01:55 AM |