If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Unable to move Visio shape
Hi,
I am trying to move a shape in Visio and it appears to be anchored (horizontally) so that I can only move it up and down on the page and place it higher or lower- if I try and move it left or right it just snaps back to it's original position. The shape is part of a template I downloaded from VisGuy (Chevrons). Any ideas gratefully received! P |
#2
|
|||
|
|||
Unable to move Visio shape
On Sun, 11 Apr 2010 03:25:01 -0700, kippers wrote:
Hi, I am trying to move a shape in Visio and it appears to be anchored (horizontally) so that I can only move it up and down on the page and place it higher or lower- if I try and move it left or right it just snaps back to it's original position. The shape is part of a template I downloaded from VisGuy (Chevrons). Best to ask on the VisGuy forum, you can post your file as an attachment so we can have a look at it. -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ |
Thread Tools | |
Display Modes | |
|
|