If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Access Auto Tab
Help Please
I am new to Access and have set up a database but I have a form on which I would like to set AutoTab (there are fourteen boxes to be filled with one letter) but I cannot seem to make it happen. Any assistance would be appreciated -- John Maw In the North sea |
#2
|
|||
|
|||
John,
You should have given a little more info on what you have tried so far, and how that failed. Check out AutoTab Property in Help. It explains how to use an input mask, and use the AutoTab property to move the cursor when you have satisfied the mask requirements. If a field has an input mask of LL and AutoTab is set to Yes, then entering "AB" in the field will cause the cursor to go to the next field in the Tab Order as soon as the "B" is entered. hth Al Camp "JohnM" wrote in message ... Help Please I am new to Access and have set up a database but I have a form on which I would like to set AutoTab (there are fourteen boxes to be filled with one letter) but I cannot seem to make it happen. Any assistance would be appreciated -- John Maw In the North sea |
#3
|
|||
|
|||
For each TextBox, set the IputMask to accept a single character (possibly
"&") and set the AutoTab Property to Yes / True. See Access Help on InputMask and AutoTab. -- HTH Van T. Dinh MVP (Access) "JohnM" wrote in message ... Help Please I am new to Access and have set up a database but I have a form on which I would like to set AutoTab (there are fourteen boxes to be filled with one letter) but I cannot seem to make it happen. Any assistance would be appreciated -- John Maw In the North sea |
#4
|
|||
|
|||
Many Thanks to you both - It works
I'm sure I shall be back now I know where to get the answers, I'm not very converseant with some of the terminology "Van T. Dinh" wrote: For each TextBox, set the IputMask to accept a single character (possibly "&") and set the AutoTab Property to Yes / True. See Access Help on InputMask and AutoTab. -- HTH Van T. Dinh MVP (Access) "JohnM" wrote in message ... Help Please I am new to Access and have set up a database but I have a form on which I would like to set AutoTab (there are fourteen boxes to be filled with one letter) but I cannot seem to make it happen. Any assistance would be appreciated -- John Maw In the North sea |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Conversion Problems | Katherine R | New Users | 11 | December 19th, 2004 12:38 AM |
Images in a database | Franz | General Discussion | 10 | October 7th, 2004 09:35 AM |
auto archive - how to access after? | mosh | General Discussion | 2 | September 28th, 2004 12:55 AM |
Adding staff photographs to my database | KK | New Users | 2 | September 3rd, 2004 07:41 AM |
Access Auto populate | Eric Cárdenas [MSFT] | Using Forms | 0 | June 7th, 2004 08:13 AM |