If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Problem: Extra Page on Report
I have a 4 column report (already doubled checked the widths available and
margins). The report has a: Report Header (1.0417" - visible) Page Header (not visible) Date Header (0.2083" - visible - used to display the date and total mileage for the date) Detail (0.2083" - visible - used to display each trip and mileage) Date Footer (not visible) Page Footer (1.4688" - visible - used to display footer info & totals) Report Footer (not visible) When the data fits in the first column, everything is fine and the report is one page in length. When the second column is used, everything displays correctly on the first page, BUT a blank (except the page footer) page two is added. The only thing I think of is trying to set the total height of the column (Date headers & Detail sections) to fit within the margins, Report Header & Page Footer, but there is no setting for this. Any suggestions??? |
#2
|
|||
|
|||
Aaron,
Try reducing width and height of the report Make all your control as small as possible. Aaron wrote: I have a 4 column report (already doubled checked the widths available and margins). The report has a: Report Header (1.0417" - visible) Page Header (not visible) Date Header (0.2083" - visible - used to display the date and total mileage for the date) Detail (0.2083" - visible - used to display each trip and mileage) Date Footer (not visible) Page Footer (1.4688" - visible - used to display footer info & totals) Report Footer (not visible) When the data fits in the first column, everything is fine and the report is one page in length. When the second column is used, everything displays correctly on the first page, BUT a blank (except the page footer) page two is added. The only thing I think of is trying to set the total height of the column (Date headers & Detail sections) to fit within the margins, Report Header & Page Footer, but there is no setting for this. Any suggestions??? -- Meet Always respond to the group so that every one can gain something out of it. Message posted via AccessMonster.com http://www.accessmonster.com/Uwe/For...ports/200508/1 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two Page Report Problem | Tru | Setting Up & Running Reports | 2 | April 26th, 2005 08:36 PM |
1 extra blank page at the end of the report: pg break causing it | pepenacho | Setting Up & Running Reports | 4 | April 22nd, 2005 07:44 PM |
Extra detail format | Phil | Setting Up & Running Reports | 8 | November 10th, 2004 12:13 AM |
Table of Contents - page numbering problem | Suzan | General Discussion | 5 | June 2nd, 2004 01:42 PM |
how NOT to print page number on 1st page of report | kim | Setting Up & Running Reports | 2 | May 19th, 2004 08:51 PM |