|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 24th, 2004, 06:21 AM
|
|||
|
|||
Visio to AutoCAD again
When I do FileSave asAutoCAD dwg it still does not save anything to my folder. It is like Visio just ignores the command. Someone with AutoCAD, please help.
|
|
#2
April 24th, 2004, 07:18 AM
|
|||
|
|||
|
Visio to AutoCAD again
I've seen several postings over the years about the resulting DWG file being
empty, but I have not seen anything where the DWG file is not created. Have you tried making a test drawing with a single rectangle on it to see if you can save it to DWG? -- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "CS7" wrote in message ... When I do FileSave asAutoCAD dwg it still does not save anything to my folder. It is like Visio just ignores the command. Someone with AutoCAD, please help.
|
|
#3
April 26th, 2004, 02:21 PM
|
|||
|
|||
|
Visio to AutoCAD again
FWIW, I was able to save as an ACAD file and open it with ACAD 2k4.
I am using Visio 2k3 pro trial version.
|
|
#4
July 14th, 2004, 05:08 PM
|
|||
|
|||
|
Visio to AutoCAD again
I just downloaded a trial version, converted a Visio file to AutoCad file. When trying to open it from Cad2004, I get an error and can't open it. Any suggestions?
"Patrick" wrote: FWIW, I was able to save as an ACAD file and open it with ACAD 2k4. I am using Visio 2k3 pro trial version.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
