If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
blank page size
HI
I am using MS Publisher 2003 and I go to a blank page, then page setup and select A3 size, however, the blank page shown is still showing as a4. If I go to Print preview, then it shows the A3 page. This has only happened recently (not used A3 size for a while). As I have an A3 Printer, I want to be able to see the correct size when I am setting teh page up. Can anyone help please? Barry |
#2
|
|||
|
|||
blank page size
The first step is to set the Print setup.
The would be the size of the paper stock in the printer and the way it sets in the supply tray, portrait or landscape. Then, set the File, Page setup. -- Don - Publisher 2000® Vancouver, USA "Barry" wrote in message ... HI I am using MS Publisher 2003 and I go to a blank page, then page setup and select A3 size, however, the blank page shown is still showing as a4. If I go to Print preview, then it shows the A3 page. This has only happened recently (not used A3 size for a while). As I have an A3 Printer, I want to be able to see the correct size when I am setting teh page up. Can anyone help please? Barry |
#3
|
|||
|
|||
blank page size
Don Schmidt wrote:
The first step is to set the Print setup. The would be the size of the paper stock in the printer and the way it sets in the supply tray, portrait or landscape. Then, set the File, Page setup. Hi Did all that, but then it kept going to custom page size, eventually it took it, but took 2 or 3 attempts for some reason. Many thanks Barry |
#4
|
|||
|
|||
blank page size
Sounds like you got to where you wanted to get.
Late good news is acceptable. G -- Don - Publisher 2000® Vancouver, USA "Barry" wrote in message ... Don Schmidt wrote: The first step is to set the Print setup. The would be the size of the paper stock in the printer and the way it sets in the supply tray, portrait or landscape. Then, set the File, Page setup. Hi Did all that, but then it kept going to custom page size, eventually it took it, but took 2 or 3 attempts for some reason. Many thanks Barry |
Thread Tools | |
Display Modes | |
|
|