If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Convert to AC 07: error messages
When I open my AC03 database using AC07, my main switchboard (SB) opens, but
when I click on a button on the SB (to open a report), there is an error popping up saying, "There was an error executing a command." I try to go to Office Button - Access Options - Trusted Center - Trust Center Settings - Trusted Location and put the full path names of this database, but I still get the same error. Also, when I open my other AC03 database using AC07, I get only one button on the SB and the rest is an empty board (it supposes to have a lot of buttons on the SB) Do you know any way to fix it? Thank you in advance for your help. |
#2
|
|||
|
|||
Convert to AC 07: error messages
I saw the same thing on an Ac97 to 07 move. I could not figure out a way to
fix it. The SB's ~6 buttons were all broke. The quickest fix was to whip up a new starter page and new buttons..... -- NTC "Tim" wrote: When I open my AC03 database using AC07, my main switchboard (SB) opens, but when I click on a button on the SB (to open a report), there is an error popping up saying, "There was an error executing a command." I try to go to Office Button - Access Options - Trusted Center - Trust Center Settings - Trusted Location and put the full path names of this database, but I still get the same error. Also, when I open my other AC03 database using AC07, I get only one button on the SB and the rest is an empty board (it supposes to have a lot of buttons on the SB) Do you know any way to fix it? Thank you in advance for your help. |
Thread Tools | |
Display Modes | |
|
|