If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Excel 2007 - Chart not working
First, I must say that Excel 2007 charting is much worse to use than 97, 2000
or 2003! It is not intuitive as it was with previous versions! I created a very simple line chart. The problem I am experiencing is that is start my initial value at 0%, which is fine and then promptly goes upto 100% and stays there for all the other points. What I love even more is that when I place my cursor over each point it actually give the proper values (73%, 61%,...) but always displays the line at 100%??? Anyone ever seen this problem before? Thank you for your assistance, QB |
#2
|
|||
|
|||
Excel 2007 - Chart not working
Double click the Y (Value) axis / this should highlight that axis by placing
a box around it / right click / Format Axis . . . / Format Axis pane should launch with Axis options highlighted in orange on left hand side / check Minimum: and Maximum: settings on the right hand side and adjust them if necessary. Please hit Yes if my comments have helped. Thanks. "QB" wrote: First, I must say that Excel 2007 charting is much worse to use than 97, 2000 or 2003! It is not intuitive as it was with previous versions! I created a very simple line chart. The problem I am experiencing is that is start my initial value at 0%, which is fine and then promptly goes upto 100% and stays there for all the other points. What I love even more is that when I place my cursor over each point it actually give the proper values (73%, 61%,...) but always displays the line at 100%??? Anyone ever seen this problem before? Thank you for your assistance, QB |
Thread Tools | |
Display Modes | |
|
|