|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 1st, 2004, 03:13 PM
|
|||
|
|||
Problem with dialog box and visio diagram security
Hi
I am currently using MS WORD 2003. I am having a problem when I open a word document I have a message "The command can not be performed because dialog box is open. Click OK, and then close open dialog boxes to continue". I am also having a problem with my VISIO 2003. When I try to edit a VISIO object in MS WORD 2003, I have a error message saying "do not have access privileges" 
|
|
#2
September 21st, 2004, 05:49 PM
|
|||
|
|||
|
Jim I am having the same problem on word. Did you get any feedback on how to
correct this. Dwight "Jim" wrote: Hi I am currently using MS WORD 2003. I am having a problem when I open a word document I have a message "The command can not be performed because dialog box is open. Click OK, and then close open dialog boxes to continue". I am also having a problem with my VISIO 2003. When I try to edit a VISIO object in MS WORD 2003, I have a error message saying "do not have access privileges"
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
