If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How to merge a graphic from a Exel spreadsheet to a Word document
I have 2 graphics (a screw head and a drive, eg phillips, or slot or hex)
that I thought would be cute on my drawer labels. They didn't merge. Can I somehow make my document layout more ready to accept graphics, or maybe I should just put the graphics on the labels before i merge to them. |
#2
|
|||
|
|||
How to merge a graphic from a Exel spreadsheet to a Word document
Probably the latter, but see the "Graphics from data base" item under the
"Special merges" section of fellow MVP Cindy Meister's website at: http://homepage.swissonline.ch/cindy...r/MergFram.htm or See the article "Graphics on Labels" on fellow MVP Graham Mayor's website at http://www.gmayor.com/graphics_on_labels.htm -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "drbob.bb" wrote in message news I have 2 graphics (a screw head and a drive, eg phillips, or slot or hex) that I thought would be cute on my drawer labels. They didn't merge. Can I somehow make my document layout more ready to accept graphics, or maybe I should just put the graphics on the labels before i merge to them. |
Thread Tools | |
Display Modes | |
|
|