|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 13th, 2008, 03:12 AM
posted to microsoft.public.visio.general
|
|||
|
|||
Piping Line Jumps don't show
In my P&ID my line jumps don't show, despite my specifying them in both the
page setup and in the individual line behavior. What's wrong? 
|
|
#2
November 13th, 2008, 12:08 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Piping Line Jumps don't show
On Wed, 12 Nov 2008 19:12:01 -0800, line_jump
wrote: In my P&ID my line jumps don't show, despite my specifying them in both the page setup and in the individual line behavior. What's wrong? menu File - Page Setup - Layout and Routing check the Line jumps section -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
