If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
draw a line in form design view
I would like to separate two set of questions by drawing a line between them
instead of putting one set above or below the other so that the users will be able to see both set of questions at the same time, but knowing the difference between them. Is there a way to draw a line in form design view? Miguel |
#2
|
|||
|
|||
draw a line in form design view
Yes. There is a line in your toolbox when in design view.
-- Rick B "Miguel Vivar" wrote in message ... I would like to separate two set of questions by drawing a line between them instead of putting one set above or below the other so that the users will be able to see both set of questions at the same time, but knowing the difference between them. Is there a way to draw a line in form design view? Miguel |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Move feild entries from form to form using global variables | JackCGW | General Discussion | 11 | November 14th, 2005 05:22 AM |
Calculated fields in Form - Design view | pjb | Using Forms | 3 | September 1st, 2005 09:39 PM |
Design help, please | SillySally | Using Forms | 27 | March 6th, 2005 04:11 AM |
How to make Access stop adding records to my tables when I switch from Form view to Design view | Mister John Doe | Using Forms | 4 | January 4th, 2005 04:31 AM |
Access 97 form will only display in design view | Lee | Using Forms | 1 | September 29th, 2004 05:04 AM |