If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hyperlinks Disabled in Office 2007
I can no longer click through a hyperlink in Outlook or Word. When I attemt
to, I get the following error message: " This operation has ben cancelled due to restrictions in effect on this computer. Please contact your system administrator". I though it might be a Norton problem, but it is not. They suggested I contact MS to diagnose the root of the issue. Any ideas where to start and how to correct the problem? -- Jerry |
#2
|
|||
|
|||
Hyperlinks Disabled in Office 2007
You receive an error message when you click a hyperlink in Outlook
http://support.microsoft.com/kb/310049 Jemckenna wrote: I can no longer click through a hyperlink in Outlook or Word. When I attemt to, I get the following error message: " This operation has ben cancelled due to restrictions in effect on this computer. Please contact your system administrator". I though it might be a Norton problem, but it is not. They suggested I contact MS to diagnose the root of the issue. Any ideas where to start and how to correct the problem? |
#3
|
|||
|
|||
Hyperlinks Disabled in Office 2007
This KB article only refers to IE 7. I'm running IE 8. Nevertheless, I
reset the advanced options, but was unable to correct the problem. Suggestions? -- Jerry "Bob I" wrote: You receive an error message when you click a hyperlink in Outlook http://support.microsoft.com/kb/310049 Jemckenna wrote: I can no longer click through a hyperlink in Outlook or Word. When I attemt to, I get the following error message: " This operation has ben cancelled due to restrictions in effect on this computer. Please contact your system administrator". I though it might be a Norton problem, but it is not. They suggested I contact MS to diagnose the root of the issue. Any ideas where to start and how to correct the problem? . |
Thread Tools | |
Display Modes | |
|
|