|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 20th, 2005, 07:49 PM
|
|||
|
|||
When I pull up a blank word document I cannot convert it to inche.
Before we spent a fortune to upgrade I could pull up a blank word document
and across the top and sides it would have inches. Everyone in this office has tried to set it up this way and has failed. This is very frustrating. 
|
|
#2
January 20th, 2005, 08:21 PM
|
|||
|
|||
|
In Word, click on Tools | Options | General | Measurement units: Inches
| OK. If this setting doesn't change the ruler, then see http://support.microsoft.com/?kbid=299339 "You cannot change ruler measurement unit from character units after upgrade to Office XP". Inches wrote: Before we spent a fortune to upgrade I could pull up a blank word document and across the top and sides it would have inches. Everyone in this office has tried to set it up this way and has failed. This is very frustrating.
|
|
#3
January 20th, 2005, 09:53 PM
|
|||
|
|||
|
See http://www.gmayor.com/Character_Units.htm
-- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA Word MVP FAQ site: http://word.mvps.org Email cannot be acknowledged; please post all follow-ups to the newsgroup so all may benefit. "Inches" wrote in message ... Before we spent a fortune to upgrade I could pull up a blank word document and across the top and sides it would have inches. Everyone in this office has tried to set it up this way and has failed. This is very frustrating.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do I create & merge specific data base & master documents? | maggiev | New Users | 2 | January 12th, 2005 11:30 PM |
| WordPerfect - copying formatting | Morgan | Page Layout | 1 | January 10th, 2005 05:00 PM |
| macro in word | js | General Discussion | 1 | December 28th, 2004 03:01 AM |
| How to run word and pass a mail merge values and fax it to the recipient | Belinda | Mailmerge | 2 | June 13th, 2004 12:49 AM |
| Need a document that pops up a dialog box for user to enter info to merge | Bomber | Mailmerge | 6 | May 12th, 2004 01:45 AM |
Linear Mode
