|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 16th, 2004, 12:25 AM
|
|||
|
|||
report zoom other than fit"
When viewing a report can the zoom be preset to something
other than "fit"?? No one can read "fit" 
|
|
#2
July 16th, 2004, 03:46 AM
|
|||
|
|||
|
report zoom other than fit"
On Thu, 15 Jul 2004 16:25:22 -0700, Skip wrote:
When viewing a report can the zoom be preset to something other than "fit"?? No one can read "fit" If you open the report from an event on a form (i.e. Command Button click event), code the event: DoCmd.OpenReport "ReportName", acViewPreview DoCmd.RunCommand acCmdZoom100 The Zooms available are acCmdZoom10, 25, 50, 75, 100, 200, 500, 1000 as well as acCmdFitToWindow -- Fred Please only reply to this newsgroup. I do not reply to personal email.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Restrict Report To Current Record | Katherine R | Setting Up & Running Reports | 1 | July 15th, 2004 07:23 PM |
| Restrict Report to Current Record | Katherine R | Setting Up & Running Reports | 1 | July 15th, 2004 07:23 PM |
| Specify Filter criteria before running report | Nikos Yannacopoulos | Setting Up & Running Reports | 3 | June 25th, 2004 09:36 PM |
| Label | SRIT | General Discussion | 2 | June 22nd, 2004 09:42 PM |
| need help make a report | [email protected] | General Discussion | 2 | June 16th, 2004 08:31 PM |
Linear Mode
