|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 10th, 2008, 01:58 PM
posted to microsoft.public.visio.general
|
|||
|
|||
Comments Added to diagram
I have not been able to 'glue' an inserted comment to a shape to keep them
together. 'Grouping' does not work. Can not attach with connector. 
|
|
#2
December 10th, 2008, 02:40 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Comments Added to diagram
On Wed, 10 Dec 2008 05:58:31 -0800, Ted Corsaro Ted
wrote: I have not been able to 'glue' an inserted comment to a shape to keep them together. 'Grouping' does not work. Can not attach with connector. Can you tell us exactly which shapes you are using, and from which stencils? -- Regards, Paul Herber, Sandrila Ltd. Electrical for Visio http://www.electrical.sandrila.co.uk/
|
|
#3
December 10th, 2008, 02:48 PM
posted to microsoft.public.visio.general
|
|||
|
|||
|
Comments Added to diagram
There are numerous ways of adding comments to a visio drawing. Each of them
are slightly different. Inserting a Comment from the menu bar is at the page level, not the shape. At the shape level, select the shape and then use the "edit shape screen tip". al "Ted Corsaro" Ted wrote in message ... I have not been able to 'glue' an inserted comment to a shape to keep them together. 'Grouping' does not work. Can not attach with connector.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
