If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Label missing
When I drag over a text box from the tool bar, the text box comes over fine
but no label comes over with it. I'm wondering if I changed a setting somewhere, but I can't find anything. Has anyone run into this? -- Thanks for any assistance |
#2
|
|||
|
|||
Label missing
I believe I could replicate this behavior if I:
1. dragged over a new textbox (it comes with a label control) 2. deleted the label control 3. highlighted the textbox (without an attached label control) 4. set the (new) default properties for that type of control (the textbox) to match the highlighted control To put it back to default (i.e., with label control), I'd: 1. first check to see if there was a "restore default" checkbox/setting in options 2. or add a textbox, add a label, highlight and cut the label, highlight the textbox and 'paste' the label to it Good luck! Regards Jeff Boyce Microsoft Office/Access MVP "NNlogistics" wrote in message ... When I drag over a text box from the tool bar, the text box comes over fine but no label comes over with it. I'm wondering if I changed a setting somewhere, but I can't find anything. Has anyone run into this? -- Thanks for any assistance |
#3
|
|||
|
|||
Label missing
Thanks Jeff. I dont think its a big issue. It only happens on one
form.?????? Just curious. -- Thanks for any assistance "Jeff Boyce" wrote: I believe I could replicate this behavior if I: 1. dragged over a new textbox (it comes with a label control) 2. deleted the label control 3. highlighted the textbox (without an attached label control) 4. set the (new) default properties for that type of control (the textbox) to match the highlighted control To put it back to default (i.e., with label control), I'd: 1. first check to see if there was a "restore default" checkbox/setting in options 2. or add a textbox, add a label, highlight and cut the label, highlight the textbox and 'paste' the label to it Good luck! Regards Jeff Boyce Microsoft Office/Access MVP "NNlogistics" wrote in message ... When I drag over a text box from the tool bar, the text box comes over fine but no label comes over with it. I'm wondering if I changed a setting somewhere, but I can't find anything. Has anyone run into this? -- Thanks for any assistance |
Thread Tools | |
Display Modes | |
|
|