If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
how to make textbox in access form display multi-paragraph textcontent?
Hi. I have a table with a MEMO field, so that I can put some
paragraphs of text in. Then I want to display the multi-paragraph text in a bounded textbox in a form, but all the carriage returns were not displayed. That meaning all the paragraphs were joined to one when they are in the textbox. How can I set the textbox to be able to display multi-paragraph text? Do I have to use windows forms textbox? The following is a sample of the text I put in the MEMO field. The carriage returns are made by using "CHR(10) & CHR(13)" If an insurer’s accounting policies do not require a liability adequacy test that meets the minimum requirements of paragraph 16, the insurer shall: (a) determine the carrying amount of the relevant insurance liabilities1 less the carrying amount of: (i) any related deferred acquisition costs; and (ii) any related intangible assets, such as those acquired in a business combination or portfolio transfer (see paragraphs 31 and 32). However, related reinsurance assets are not considered because an insurer accounts for them separately (see paragraph 20). (b) determine whether the amount described in (a) is less than the carrying amount that would be required if the relevant insurance liabilities were within the scope of IAS 37. If it is less, the insurer shall recognise the entire difference in profit or loss and decrease the carrying amount of the related deferred acquisition costs or related intangible assets or increase the carrying amount of the relevant insurance liabilities. |
#2
|
|||
|
|||
how to make textbox in access form display multi-paragraph text co
I'm not sure if this will help but in my forms I have my Memo Properties:
Enter Key Behaviour set to "New Line In Field" and I have no problems. "leontancfa" wrote: Hi. I have a table with a MEMO field, so that I can put some paragraphs of text in. Then I want to display the multi-paragraph text in a bounded textbox in a form, but all the carriage returns were not displayed. That meaning all the paragraphs were joined to one when they are in the textbox. How can I set the textbox to be able to display multi-paragraph text? Do I have to use windows forms textbox? The following is a sample of the text I put in the MEMO field. The carriage returns are made by using "CHR(10) & CHR(13)" If an insurer’s accounting policies do not require a liability adequacy test that meets the minimum requirements of paragraph 16, the insurer shall: (a) determine the carrying amount of the relevant insurance liabilities1 less the carrying amount of: (i) any related deferred acquisition costs; and (ii) any related intangible assets, such as those acquired in a business combination or portfolio transfer (see paragraphs 31 and 32). However, related reinsurance assets are not considered because an insurer accounts for them separately (see paragraph 20). (b) determine whether the amount described in (a) is less than the carrying amount that would be required if the relevant insurance liabilities were within the scope of IAS 37. If it is less, the insurer shall recognise the entire difference in profit or loss and decrease the carrying amount of the related deferred acquisition costs or related intangible assets or increase the carrying amount of the relevant insurance liabilities. |
#3
|
|||
|
|||
how to make textbox in access form display multi-paragraph text content?
On Tue, 1 Jul 2008 18:56:18 -0700 (PDT), leontancfa
wrote: How can I set the textbox to be able to display multi-paragraph text? Set the Form's "Enter Key Behavior" property to "New line in field". Use a Memo datatype in order to hold large amounts of text. -- John W. Vinson [MVP] |
Thread Tools | |
Display Modes | |
|
|