If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Do not show lack of data as a zero on graph lines, leave blank
I used to know this but got new software. If I leave a blank in a line of
data and at the end of the data, the graph line drops to zero. I just want it to igore blank spaces. |
#2
|
|||
|
|||
Do not show lack of data as a zero on graph lines, leave blank
1) replace blank by =NA(); displays as #N/A
OR 2) click on chart; use Tools|Options; open Chart tab; set how to Plot Empty cells best wishes -- Bernard V Liengme www.stfx.ca/people/bliengme remove caps from email "Just Joe" Just wrote in message ... I used to know this but got new software. If I leave a blank in a line of data and at the end of the data, the graph line drops to zero. I just want it to igore blank spaces. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sort pages? | David | General Discussion | 15 | May 13th, 2005 11:33 PM |
How do I print blank lines in WORD 2002 when data fields are empty | Karen C. | Mailmerge | 2 | April 22nd, 2005 10:39 AM |
Blank lines show in address control | Susan L | Setting Up & Running Reports | 2 | April 15th, 2005 12:35 PM |
Lines in graph only if values in fields | Jon Peltier | Charts and Charting | 0 | December 5th, 2003 05:24 PM |
Dynamically control how many lines on a graph? | Keith R | Charts and Charting | 2 | October 22nd, 2003 04:19 PM |