If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Glue Points / Connection Points
I am creating new master drawings of equipment my company uses. I am trying
to add Glue points. I open the master which is all grouped and click on it, then using the connection point tool from the menu bar hold the ctrl button and add a connector to my drawing. Good so far. Now I close the master and save the changes. Open a new drawing drag in a Server rack then drag in my new drawing and the glue points don't work. Yes, the snap and glue are active. What am I not doing to get this to work??????? |
#2
|
|||
|
|||
Glue Points / Connection Points
Your equipment shapes need to be converted to 1-D objects. Make your custom
stencil editable, then double click your master object to edit it. Right click the shape, formatbehaviorInteraction Styleselect line (1-D). Most likely, the connection points will be centered vertically. Right click the shape again, open the shapesheet. In the Shape Transform section, change the cell value for LocPinY to be 0 or Height*0. Either will work. Save and close your master. Wapperdude "Rob Stone" wrote: I am creating new master drawings of equipment my company uses. I am trying to add Glue points. I open the master which is all grouped and click on it, then using the connection point tool from the menu bar hold the ctrl button and add a connector to my drawing. Good so far. Now I close the master and save the changes. Open a new drawing drag in a Server rack then drag in my new drawing and the glue points don't work. Yes, the snap and glue are active. What am I not doing to get this to work??????? |
Thread Tools | |
Display Modes | |
|
|