If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
" & " in a label
I'm using Access 97. I have a report that requires in the
report header, in a label to Say "EG&G" I can not get the & to show. once I preview it. it show in the box on the label and in the caption of the property window. How do I do this? Dennis |
#2
|
|||
|
|||
Use EG&&G and it will show the ampersand!!
-----Original Message----- I'm using Access 97. I have a report that requires in the report header, in a label to Say "EG&G" I can not get the & to show. once I preview it. it show in the box on the label and in the caption of the property window. How do I do this? Dennis . |
#3
|
|||
|
|||
Thank you so much.
Dennis -----Original Message----- Use EG&&G and it will show the ampersand!! -----Original Message----- I'm using Access 97. I have a report that requires in the report header, in a label to Say "EG&G" I can not get the & to show. once I preview it. it show in the box on the label and in the caption of the property window. How do I do this? Dennis . . |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Label reverts to default page setup | Jim Tinder | Setting Up & Running Reports | 2 | September 2nd, 2004 01:13 PM |
Label | SRIT | General Discussion | 2 | June 22nd, 2004 09:42 PM |
Root | j.w. jang | General Discussion | 1 | June 22nd, 2004 03:34 PM |
OT- label making | Erika | Publisher | 4 | May 26th, 2004 06:27 AM |
Alignment the text in Inventory label | Lee | Charts and Charting | 0 | February 26th, 2004 03:16 PM |