If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
record soource & parameters
I am trying to change the record source for two controls
in a report. I want the report to run based on parametrs entered. e.g. requested by & date. In design view I can only change the record source for all controls. How do i get the report to show parameters for only two controls before it runs. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Button to print current record only | Fatz | Using Forms | 6 | June 17th, 2004 01:58 PM |
Problems with record locking | Ronny Salomonsen | General Discussion | 0 | June 14th, 2004 09:37 AM |
Form Doesn't Go To New Record | Steve | New Users | 15 | May 16th, 2004 04:33 PM |
Form Does Not Go To New Record | Steve | New Users | 1 | May 12th, 2004 03:15 AM |
Avoid Creating A Duplicate Record | Mark | New Users | 4 | May 11th, 2004 01:52 AM |