If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2007 looses VBA Code when trust center location not added
I'm using 2 PCs. Both Vista. My 2nd PC seems to have corrupted my database
and lost the VBA code when I tried to open it without setting the location in the trust center. Once it can't find the VBA the database seems to be corrupted. I can't get it to work again. Switchboard doesn't work, none of the buttons work. Anything that uses a module or code doesn't work. It also did the same thing at a client who is running on Windows XP so the problem seems to be in Access. I can see where it would ask you if you want to run the database but this is corrupted now. |
#2
|
|||
|
|||
2007 looses VBA Code when trust center location not added
Try setting the Macro Security to Low:
Tools Macro Security Then build a Trusted Location and set the security back on if you like. -- Arvin Meyer, MCP, MVP http://www.datastrat.com http://www.mvps.org/access http://www.accessmvp.com "BillieGoat" wrote in message ... I'm using 2 PCs. Both Vista. My 2nd PC seems to have corrupted my database and lost the VBA code when I tried to open it without setting the location in the trust center. Once it can't find the VBA the database seems to be corrupted. I can't get it to work again. Switchboard doesn't work, none of the buttons work. Anything that uses a module or code doesn't work. It also did the same thing at a client who is running on Windows XP so the problem seems to be in Access. I can see where it would ask you if you want to run the database but this is corrupted now. |
Thread Tools | |
Display Modes | |
|
|