If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
populating shapes
It would seem logical to me to be able to double-click and shape and have it
go on to the sheet rather than the more tedious process of having to drag every shape onto the drawing page. Also, when a shape is moved, the connectors should be automatically moved to the closest connector. So when a shape is moved from the left to the right of another shape it seems like visio should recognize and reroute the connectors appropriately. ---------------- This post is a suggestion for Microsoft, and Microsoft responds to the suggestions with the most votes. To vote for this suggestion, click the "I Agree" button in the message pane. If you do not see the button, follow this link to open the suggestion in the Microsoft Web-based Newsreader and then click "I Agree" in the message pane. http://www.microsoft.com/office/comm....visio.general |
#2
|
|||
|
|||
populating shapes
On Thu, 1 Apr 2010 11:53:04 -0700, Babz wrote:
It would seem logical to me to be able to double-click and shape and have it go on to the sheet rather than the more tedious process of having to drag every shape onto the drawing page. Whereabouts on the page should the shape go? -- Regards, Paul Herber, Sandrila Ltd. Electronics for Visio http://www.sandrila.co.uk/visio-electronics/ Electrical for Visio http://www.sandrila.co.uk/visio-electrical/ Electronics Packages for Visio http://www.sandrila.co.uk/visio-electronics-packages/ |
Thread Tools | |
Display Modes | |
|
|