If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
I CAN'T GET MY CHART TO PRINT ON SAME PAGE WITH MY SPREADSHEET
I created a spreadsheet in Excel 7. Then I selected data from the
spreadsheet and created a chart in the same worksheet and placed the chart under the spreadsheet with primary and secondary axis. Of course, the chart is dynamic and changes as the data in the spreadsheet changes. I shrunk the height and stretched the chart to span most of the landscape width of the spreadsheet. I set the print area to include the entire spreadsheet and chart. (As a side note, I have had alot of difficulty printing from Excel to an HP T1120 plotter in custom plot sizes, so I plot to an adobe pdf driver to create a pdf with a custom page size and orientation and then open the pdf file and plot to the T1120 plotter.) My problem is that when I open the pdf and preview the print, the chart is not visible and doesn't print. In addition, I recently started getting a preview that only shows a portion of the spreadsheet and the whole spreadsheet doesn't print. I've tried everything I can think of without any success. Can anyone help on these two issues? |
#2
|
|||
|
|||
I CAN'T GET MY CHART TO PRINT ON SAME PAGE WITH MY SPREADSHEET
Page Setup/ Page/ Fit to 1 page wide by 1 page tall.
-- David Biddulph "pdlann" wrote in message ... I created a spreadsheet in Excel 7. Then I selected data from the spreadsheet and created a chart in the same worksheet and placed the chart under the spreadsheet with primary and secondary axis. Of course, the chart is dynamic and changes as the data in the spreadsheet changes. I shrunk the height and stretched the chart to span most of the landscape width of the spreadsheet. I set the print area to include the entire spreadsheet and chart. (As a side note, I have had alot of difficulty printing from Excel to an HP T1120 plotter in custom plot sizes, so I plot to an adobe pdf driver to create a pdf with a custom page size and orientation and then open the pdf file and plot to the T1120 plotter.) My problem is that when I open the and preview the print, the chart is not visible and doesn't print. In addition, I recently started getting a preview that only shows a portion of the spreadsheet and the whole spreadsheet doesn't print. I've tried everything I can think of without any success. Can anyone help on these two issues? |
Thread Tools | |
Display Modes | |
|
|