If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Disabled the undo and redo function
I believe while I was creating a macro, I disabled the undo and redo
function. How can I reenable them. I have checked the optins setting and that setting is correct. |
#2
|
|||
|
|||
Disabled the undo and redo function
Never mind I just had to close and rest VISIO. Still no sure how I disable it
though. |
Thread Tools | |
Display Modes | |
|
|